(257GS) MODEL 602G FILTER PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 06/25/2014
257
GS
SAVE THESE INSTRUCTIONS
English
Page 7
FILTER PUMP STATIONARY MOUNTING OPTION
There are three mounting holes located at the bottom of the filter pump base. These
holes are provided because various country’s regulations, especially in the European
community, require the filter pump to be secured to the ground or to a base in a
permanent upright position.
These three holes form a triangle pattern and the holes are slotted with a 7mm width.
The filter pump can be mounted on a cement base or onto a wooden structure to prevent
accidental falling over. Total assembly must exceed 18kg. The drawings on the following
show two possible ways of upright mounting.
-- (3) x M6 HEXAGON HEAD BOLTS
119mm
119mm
91mm
119mm
91mm
119mm
-- (3) x M6 HEXAGON LOCK-NUTS
It is recommended that the filter cartridge be replaced at least every 2 weeks.
1.
Make sure filter pump is not operating. Disconnect line cord.
2.
To prevent water from escaping the pool, unscrew the pool inlet nozzle
(10)
and strainer grid
(11)
from the strainer connectors and insert the hat-like plugs into the strainer connectors.
3.
In a counter-clockwise motion, remove the filter housing collar
(12)
and threaded cover
(3)
. Be
careful not to lose the cover seal
(4)
.
4.
Remove filter cartridge
(5)
to clean it. The filter may be cleaned from the spray from a water
hose.
5.
Use judgement as to whether cartridge needs to be replaced.
6.
Return cartridge to filtering position.
7.
Return the seal
(4)
and threaded cover
(3)
to their original positions and in a clockwise direction
rescrew the housing collar
(12)
onto the filter housing.
8.
After service, open the air release valve, remove the plugs, allow any air to escape through the
valve before tightening the valve again and replace the pool inlet nozzle
(10)
and strainer grid
(11).
The pump is now primed with water again and may be turned on.
CLEANING OR REPLACING FILTER CARTRIDGES
