112
SAVE THESE INSTRUCTIONS
Page 9
(112) MODEL 6220 KRYSTAL CLEAN POOLWATER SYSTEM ENGLISH 7.5” X 10.5” PANTONE 295U 12/25/2006
For connection to filter pumps with 1-1/4” (32mm) hose size:
1.
If your above-ground-pool is filled up with water, unscrew the strainer
grids from the strainer connectors and insert the black hat-like plugs
into the strainer connectors to prevent water from flowing out of pool.
Go to step 2 directly if your pool is empty.
2.
If your above ground pool is equal
or higher than 42" (107cm) in height,
insert the water baffle adaptor A
(14)
into the saltwater system outlet as
shown in Fig. 5. Go to step 3 directly
if your pool is lower than 42" (107cm)
in height.
3.
Connect the adaptors A
(15)
to the
saltwater system as shown in Fig. 6.
Tighten securely.
NOTE:
Make sure the LED lights on the saltwater system are facing out
from the pool during the installation as shown in Fig. 6.
4.
Disconnect the water return (to the pool) hose from the filter pump
connection, and connect it to the adaptor A
(15)
on the saltwater
system outlet with a hose clamp. See Fig. 6.
5.
Connect connector hose
(17)
to the filter pump outlet (lower connection)
and saltwater system inlet with hose clamps. Tighten securely.
6.
Return strainer grids to strainer connectors inside pool after removing
black hat-like plugs that prevented water from flowing out of the pool.
SS
EE
TT
--UU
PP
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
SET-UP INSTRUCTION (continued)
Fig (5)
14
NOTE:
Remove the strainer at the pool inlet to allow the maximum flow rate of the
water to the pool.
Fig (6)
SWIMMING POOL
FILTER PUMP
15
16
15
16 17
