![background image](http://html1.mh-extra.com/html/intex/hp3220/hp3220_instruction-manual_2081114012.webp)
(307IO) MODEL HP3220 HEAT PUMP ENGLISH 7.5” X 10.3” PANTONE 295U 10/10/2017
English
307
IO
SAVE THESE INSTRUCTIONS
English
Page 12
DISPLAY CONTROL PANEL OPERATION
CONTROL UNIT PANEL
Once plugged in and the RCD is reset, the LED display will
show all the icons and numbers for 5 seconds and then shows
the ambient room temperature. The control unit panel and
heat pump are deactivated at this stage.
NOTE:
Other icons may appear on the LED display; however
this heat pump only has heating function.
On/Off
Button:
Press
to activate the control
unit panel buttons and to start the heat pump. The
LED display shows the water inlet and outlet
temperatures and the heating mode
icon.
Press again to stop the heat pump function and to deactivate the control unit panel
buttons. The LED display shows the ambient room temperature.
Temperature / Clock / Timer Adjustment Buttons:
Once the unit is activated, press
or
any time to set the desired water temperature.
Temperature range: 15 to 40°C.
Clock Time Setting Button:
1) Press
for 5 seconds to set the Clock Time, the hour (HH) digits will flash. Press
or
to adjust the hour from 00 to 23.
2)
Press again and the minute (MM) digits will flash. Press
or
to adjust
the minute from 00 to 59.
3)
Press again to confirm the Clock Time.
Timer ON / Timer OFF Setting Button:
1)
Press for 5 seconds to enter Timer ON setting, the
ON
icon and the start hour
(HH) digits will flash. Press
or
to adjust the start HOUR from 00 to 23.
2)
Press again and the start minute (MM) digits will flash. Press
or
to
adjust the start MINUTE from 00 to 59.
3)
Press again to enter Timer OFF setting, the
OFF
icon and the stop hour (HH)
digits will flash. Press
or
to adjust the stop HOUR from 00 to 23.
4)
Press again and the stop minute (MM) digits will flash. Press
or
to
adjust the stop MINUTE from 00 to 59.
5)
Press again to save the setting and exit. The LED display shows the clock
TIME and the Timer
ON
OFF
icon, indicating a start / stop times have been set.
To cancel an existing Timer setting indicated by the
ON
OFF
icon, press
for 5 seconds
and then press
. The
ON
OFF
icon will go away.
To review the start and stop times of an existing programmed Timer (indicated by the
ON
OFF
icon), press
for 5 seconds and cycle through the Timer operation by pressing
the 4 more times without making any adjustment.
TEMP
ON
OFF
C
C
IN
SET
OUT
ROOM
M