(37IO) I637USB ELECTRIC PUMP ENGLISH 4.875” X 7.25” 06/19/2021
English
37
IO
SAVE THESE INSTRUCTIONS
Page 4
dEFlATION
1. Connect the USB cable to an appropriate external power adapter. See Fig (2-5).
2. Turn the control dial to the
deflation mark ( ). See Fig
(8).
3. With the airbed fully deflated begin rolling the airbed from the end opposite of the pump
towards the end where the pump is located. See Fig (9).
4. When all the air is removed from the airbed, turn the control dial back to the off mark
( ) closing the valve.
5. Disconnect the USB cable from the external power adapter, place it inside the cord
compartment and close the cover. Make sure the USB cable is free of twists, kinks or
knots.
FIg (9)
FIg (8)
Deflation
mark
Proper inflation of the airbed.
The ambient temperatures of air have an effect on the airbed internal pressure. At low
ambient temperature the air will contract within the airbed and the airbed will feel softer:
add air as necessary. At high ambient temperature the air within the airbed will expand
significantly and the airbed will become hard and may burst: release air to avoid damage
to the airbed or to soften the feel. Do not expose the airbed to extreme temperatures (hot
or cold). Stretching is a natural characteristic of new vinyl. During initial use, the airbed
may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the airbed caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
IMPORTANT NOTE
STORAgE INSTRUCTIONS
1. Deflate the airbed following the “DEFLATION” instructions.
2. Make sure the airbed is clean and dry.
3. Lay the airbed flat with the sleeping surface facing upwards and follow the folding steps
on Figs (10 - 14). Fold the airbed loosely and avoid sharp bends, corners and creases
which can damage the airbed.
FIg (10)
FIg (11)
FIg (12)
FIg (14)
FIg (13)
4. Place the airbed inside the storage bag (if included) or the original packaging and store
in a dry place.
