(37IO) I637USB ELECTRIC PUMP ENGLISH 4.875” X 7.25” 06/19/2021
English
37
IO
SAVE THESE INSTRUCTIONS
Page 2
NOTE:
Drawings for illustration purpose only. May not reflect actual product. Not to scale.
Due to a policy of continuous product improvement, Intex reserves the right to change
specifications and appearance, which may result in updates to the instruction manual,
without notice.
PARTS REFERENCE
Part descriptions:
1. Control dial
2. Inflation mark ( )
3. Off mark ( )
4. Deflation mark ( )
5. Manual inflation port and cap
6. Cord compartment cover
7. USB cable
8. Airbed
8
3
4
6
5
7
1
2
INSTRUCTIONS
The pump uses the power supplied by a standard USB socket. Older USB adapters do not
supply enough power for the pump to fully inflate the airbed. Newer “fast charge” adapters
need to be used. Check that
your adapter’s output is 2A or more for optimum operation
.
Most USB charge ports in vehicles are too weak: a 12 volt USB adapter (12V Car Charger)
may be needed. If the pump won’t inflate the bed fully within 7 minutes, you probably need
higher output.
general
• The air pump requires an external
power adapter (not included) to operate.
• Air pump input voltage / current
rating: 5V / 2A or more.
• Make sure the output of the external power adapter, such as
USB Wall Charger, Portable
USB Charger, 12V Car Charger or USB Port is rated 5V / 2A or more.
• No
specific air pump maintenance is required. Air pump has no user serviceable parts.
•
Make sure the area is flat, level, clean and free from sharp objects. To prevent puncture
or damage to the airbed, never drag the airbed across the ground. Lift the inflated airbed
when moving or changing location.
•
During outdoor use, place a protective layer such as a tarp (not included) between the
selected surface and the airbed in order to prevent damage to the airbed.
•
For cleaning use only clean cloth with mild soapy solution. Do not use any chemicals.
• In case of repairs, use only common PVC repair glue and patches.
For flocked surfaces:
rub away the flocking material with an eraser first before applying the glue and/or patch.
