(20PO) AP619DA ELECTRIC PUMP ENGLISH 4.875” X 7.25” 08/25/2022
20
PO
READ AND SAVE THESE INSTRUCTIONS
Page 4
MANUAL INFLATION OPTION
If electrical power is not available, a conventional foot, manual, or battery-operated air
pump can be used by connecting it to the manual inflation port located inside the line cord
compartment. See Fig (8). Follow these steps:
1. Open line cord compartment cover.
2. Remove the cap from the manual inflation port
and insert the nozzle of the pump into the port.
Inflate the airbed to desired firmness.
NOTE:
Do not overinflate. The firmness should be
approximately the same as the level achieved with
the internal electric pump.
3. Remove nozzle from manual inflation port and
close the cap and the line cord cover.
FIG (8)
DEFLATION
1. Plug in the AC power
cord into an AC electrical outlet. See Fig (2).
2.
Press the deflation button ( ) to deflate.
See Fig (6).
3. When all the air is removed from the
air bed
,
press “ ” again to switch OFF.
Note:
The pump will automatically switch OFF after about five and half minutes of
operation when the pump is left unattended.
4. With the
air bed
fully deflated begin rolling the
air bed
from the end opposite of the pump
towards the end where the pump is located. See Fig (7).
5. Disconnect the AC power cord from the electrical outlet, coil the line cord and place it
inside the cord compartment, then close the cover. Make sure the power cord is free of
twists, kinks or knots.
FIG (6)
FIG (7)
STORAGE INSTRUCTIONS
1. Deflate the
air bed
following the “DEFLATION” instructions.
2. Make sure the
air bed
is clean and dry.
3. Lay the
air bed
flat with the sleeping surface facing upwards and follow the folding steps
on Figs (9 - 13). Fold the
air bed
loosely and avoid sharp bends, corners and creases
which can damage the
air bed
.
FIG (9)
FIG (10)
FIG (11)
FIG (13)
FIG (12)
4. Place the
air bed
inside the storage bag and store in a dry place.
