(20PO) AP619DA ELECTRIC PUMP ENGLISH 4.875” X 7.25” 08/25/2022
20
PO
READ AND SAVE THESE INSTRUCTIONS
Page 3
INFLATION
1. Open cord compartment cover and remove power cord.
See Fig (1).
2. Plug in the AC power
cord into an AC electrical outlet. See Fig (2).
3.
Press the inflation button ( ) to inflate.
See Fig (3).
4.
When the air bed is inflated to the desired firmness, press “ ” again to switch OFF.
Note:
The pump will automatically switch OFF after about five and half minutes of
operation when the pump is left unattended or when air bed is fully inflated.
5. Lie down on the
air bed
to test the firmness.
6.
If the air bed feels too firm, adjust the firmness by pressing the deflation button ( ) to
deflate.
See Fig (4).
NOTE:
This will start deflating the air bed quickly, press “ ” again to switch OFF after a
second or so.
Test the firmness and repeat for a second at a time until you have reached
the desired firmness.
Alternatively, you can do this process by pressing the deflation adjust button “ ”, which
will allow air to be released slowly and short.
See Fig (5).
It will automatically return to
the closed state after completion, press “ ” again to repeat deflating until the air bed
reaches the desired firmness.
FIG (3)
FIG (4)
FIG (5)
FIG (1)
Proper inflation of the
air bed
.
The ambient temperatures of air have an effect on the
air bed
internal pressure. At low
ambient temperature the air will contract within the
air bed
and the
air bed
will feel softer:
add air as necessary. At high ambient temperature the air within the
air bed
will expand
significantly and the
air bed
will become hard and may burst: release air to avoid damage
to the
air bed
or to soften the feel. Do not expose the
air bed
to extreme temperatures
(hot or cold). Stretching is a natural characteristic of new vinyl. During initial use, the
air
bed
may become soft and require additional inflation to maintain desired firmness. This is
normal for the first few days of use. Dimensions shown are approximate and will vary due
to the vinyl temperature and the air temperature.
In no event shall Intex, their authorized agents or employees be liable for damages
(such as pin holes) to the
air bed
caused by negligence, ordinary wear and tear,
abuse and carelessness, or external forces.
IMPORTANT NOTE
FIG (2)
110V – 120V
220V – 240V
√
