279
IO
(279IO) EXPLORER PRO 50 BOAT ENGLISH 4.875”X7.25” 07/27/2015
Page 3
SAVE THESE INSTRUCTIONS
Description
Explorer pro 50
•
Manual propulsion by paddle mean.
•
Maximum permissible number of person: 1 child.
•
Maximum working air pressure: 0.03 bar.
NOTE:
Drawings for illustration purpose only. Actual product may vary. Not to scale.
Descriptions
1
Grab handle
3
Inflation valve
2
All around grab line
2
1
3
Inflating Instructions
Before starting, locate a clean area free of stones or other sharp objects. Unroll the boat so
it is laid out flat, and locate your pump.
Use a hand or foot operated air pump to inflate the boat. Do not use high-pressure air
compressors. Adults should inflate the chambers following the numerical sequence marked
on the valves. It is very important to follow the numerical sequence; failure to do so will
result in an improperly inflated boat. Fill each chamber until it is stiff to the touch but NOT
hard. Use the enclosed ruler to check the main chamber for proper inflation. DO NOT
OVER INFLATE. Fill with cold air only.
IMPORTANT:
Air temperature and weather condition do affect the internal air pressure of
inflatable products. In cold weather the product will lose some pressure due to the fact that
the air will contract. If this occurs, you may want to add a little air to the product. However,
in hot weather, the air will
expand. You must let some air out to prevent the product from failing due to overpressure.
Grab Line Installation:
IMPORTANT:
To properly install the inflatable
boat’s grab line and/or accessory lines, first
inflate the boat.
If is necessary, begin the grab line installation at
the rear of the boat by threading it through the
rope holders completely around the outside of
the boat. Tie the two loose ends in a square
knot at the rear end of the boat.
Square knot
" " -
Recommended seating arrangement of the occupants.
