Setup Procedures for the 44 Sojourn
Clean mounting areas with
acetone.
Install sealant around
studs and openings
Replace plastic gromments in top of
arch stubs with new ones supplied.
Preparation
IMPORTANT: Install drain plug in Transom of boat first.
Refer to instructions for Prop Installation.
Install Arch Stubs on studs and hold in place until hardware is installed.
Use tape for alignment reference.
NOTE: On inside of both arch stubs is a bracket for windshield support. Carefully work around bracket
so you do not damage windshield.
Aft Tape
Side tape on outside
Install flat plate, flat washer,
lock washer and SS nut.
Arch Stub
Support Bracket
Windshield
Tighten in place when aligned with tape.
