(329PO) MODEL ECO5110&6110 SALTWATER SYSTEM ENGLISH 7.5” X 10.3” PANTONE 295U 01/22/2021
329
PO
SAVE THESE INSTRUCTIONS
English
Page 17
OPERATION INSTRUCTIONS
1. Turn on the filter pump.
2
.
Start up the unit:
Plug the power cord into the electrical outlet and test the GFCI/RCD
(circuit breaker). Press
button. Flashing code “00” appears on the
electronic control station’s LED, indicating that the unit is ready to be
programmed.
3. Set operating hours for Saltwater system:
With code “00” flashing, press
button to set
the desired operating hours. See the “Operating
Time Table” for the required operating hours related
to each pool size. Pressing
will increase the time
from 01 to 12 hours maximum. If you have selected
too many hours keep pressing
to repeat the
cycle. The built-in timer will now activate your
Saltwater System, at the same time each day, for
the number of hours you have set.
NOTE:
The Saltwater System will not operate if the filter pump is not operating. Make
sure to program your filter pump (or start it manually) for operation beginning 5 minutes
before the saltwater system and finishing 15 minutes after the saltwater system.
4
.
Lock keypad controls:
With the desired hour value showing, press
button until you hear a
“beep”. A green “WORKING” indicator on the control panel will light up
within a few seconds to indicate that the saltwater system has started
sodium hypochlorite production. Locking the control buttons into this
setting prevents unauthorized changing of the operating cycle.
NOTE:
If you forget to lock the keypad controls, the system will
automatically lock it and start working 1 minute later.
5. Readjust operating time if necessary:
The operating hours can be re-adjusted if necessary. Press
button
until you hear a “beep” to unlock the keypad and the current programmed
time will flash. Repeat steps 3 to 4.
(1 to 12 hours max per cycle)
