7
WARNING: To reduce the risk of injury, user must read and understand operator’s manual.
Move the strip forward until the 2nd empty slot is aligned
with the bit. This will allow for the proper strip advancement
once the nose piece is depressed.
To remove the strip, pull it through from the top of the
nose piece. Whenever possible, hold the tool at a right angle to
the work surface.
Pull the trigger to start the motor. Press the nose piece,
with constant force, against the work surface. Do not
remove the tool from the work surface until the clutch
disengages and the bit stops rotating, signalling a fully driven
screw. Continue to allow the motor to run. The next screw will be
automatically fed into place when the tool is depressed against
the work surface.
This tool is equipped with a depth control adjustment.
Test drive one screw before finalizing the depth to ensure
appropriate countersink. Adjust the countersink by turning the
depth adjustment thumb wheel: Refer to the graphics on the tool
for proper direction.
This tool has a depth-sensing clutch. When the screw is
countersunk to the pre-set depth, it automatically disengages
and makes a click or racheng sound. This is normal and signals
completion of the drive.
When the battery is low or the drive requires too much
torque, the tool may stall at the bottom of the drive (before the
clutch can disengage). Continuous operation in this manner can
cause over-heating and permanent damage.
Switch tool from forward to reverse: To switch to reverse, push
reverse button. Remove the strip, pull it through from the top of
the nose piece.
Depress nose piece while inserting bit into screw. Maintain
forward pressure on tool. Pull the trigger to start motor.
Changing the bit: Due to wear or damage, the bit will need to be
replaced periodically or when changing from Phillips to Square
Drive fasteners.
• Press the button to disassemble
the nail box(Fig.4)
• Material assembly and
dismantle explanation:
Push down the flexible
shaft and load the bit(Fig.5)
• Push the nail box to be fitted
closely with the screwdriver.
(Fig.6)
• Press the button to assemble
the nail box (Fig.7)
• Operation explanation:
Adjusting the nail box to the
suitable measurement
according to the screw size
(there’s scale on the plate and
just press down the adjustment
button to adjust screw
nail size)(Fig.8)
• Push the nail band along the
bottom chute.(Fig.9)
• Push the nail band to the
outlet,then close the guard
cover and pull out the nail
band.(Fig.10)
• Button the nail band tip on the
nail-feeder gear socket.(Fig.11)
• Adjusting the nail to the
suitable depth.(Fig.12)
• Operate the screwing process
(same with the screwdriver
process,the difference is don’t
need to support with hand and
Auto-feeding). (Fig.13)
Operation
FIG.4
FIG.7
FIG.8
FIG.9
FIG.10
FIG.11
FIG.12
FIG.13
FIG.5
FIG.6
