6
Intex ASG18V
intex.com.au
|
intex.co.nz
WARNING: Before attempting to use any tool,
make sure your are familiar with all operating features
and safety requirements.
A
Adjustable Nose Piece
B
Belt Hook
C
Forward / Reverse Switch
D
Cushioned Trigger
E
Press Button to Release the attachment
F
Screw Guard
G
Comfortable Grip
H
Charger
I
Press down the
adjustment button
to adjust screw nail size
J
Depth of Drive Control
K
Main screwdriver
M
Battery
L
Carbon brush
BATTERY CHARGING
To charge the battery pack it must
first be removed from the drill.
To remove the battery pack, grasp
both sides of the battery pack and
depress that battery clips as shown
if Fig 1. Now gently pull the battery
pack from the housing.
WARNING: Excessive tightening by hand
may damage the screw.
•
FORWARD REVERSE SWITCH
This switch determines the direction of rotation of the bit,
ie. clockwise or counter clockwise. To alter the direction of
rotation stop the drill then push the selection lever to the
left of right. When the lever is in the “F” (Forward) position
the bit will rotate clockwise. When the lever is in the “R”
(Reverse) position the bit will rotate counter clockwise.
Before operation check that the switch is set in the required
position.
•
TRIGGER
When the trigger is depressed the bit will rotate (provided the
forward/ reverse switch is set in the forward or reverse
position)The trigger can be locked in the OFF position. This
helps reduce the possibility of accidental starting when not in
use. To lock trigger, place selection lever in the center position.
WARNING
: Be prepared for binding or break through. When
these situations occur, the drill has a tendency to grab and kick
in the opposite direction, and could cause loss of control. If
you are not prepared, this loss of control can result in possible
serious injury.
WARNING
: Always wear safety goggles or safety glasses with
side shields when operating tool. Failure to do so could result
in objects being thrown into your eyes, resulting in possible
serious injury.
WARNING
: Read all instructions Failure to follow all
instructions listed below may result in electric shock, fire and/or
serious injury. The term “power tool” in all of the warnings listed
below refers to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
WARNING
: Read section titled ‘Safety Warnings’ before
maintaining tool.
For best results, charge new battery before using. Loading the
Tool: Check to be sure the heads of the screws are resting on
top of the plastic collation material. This will prevent damage to
the strip guide. Check for proper fastener length setting. Feed
the strip into the strip guide. The screw guard may be removed
to simplify the loading process.
H
A
K
I
E
D
F
B
G
C
J
M
L
Operation
FIG.2
F/R Switch
Trigger
FIG.3
FIG.1
