(114BS) ELECTRIC POOL HEATER ENGLISH 7.5” X 10.3” PANTONE 295U 08/16/2015
English
114
BS
SAVE THESE INSTRUCTIONS
English
Page 5
SET UP INSTRUCTIONS
The appliance is ready to work under the following conditions:
FREE CHLORINE (HCIO + CIO- +CI
2
) up to 3 ppm
pH
6.8 - 8.0
CHLORIDES
up to 250 ppm
ISOCYANIC ACID
up to 100 ppm
CALCIUM HARDNESS
up to 500 ppm
BROMIDE (HBrO)
up to 8 ppm
IMPORTANT:
The electrical pool heater must be installed as the last piece of pool
equipment before the saltwater pool or chlorine generator system in the water return
line to the pool.
1.
Assemble the above-ground-pool (AGP) and its filter pump per installation
instructions.
2.
Remove the electrical pool heater and it’s accessories from the packaging.
3.
Place the electrical pool heater in line after the filter pump.
4.
Connect the hose
(1)
to the electrical pool heater inlet. (See following page)
5.
If your above-ground-pool is filled up with water, unscrew the strainer grids from the
strainer connectors and insert the black hat-like plugs into the strainer connectors
before electrical pool heater installation. Go to step 6 directly if your pool is empty.
6.
Disconnect the water return (to the pool) hose from the filter pump connection, and
connect it to the upper electric pool heater connection with a hose clamp.
7.
Connect the second hose to the lower electric pool heater connection and to the
lower pump connection. Make sure all the hose clamps
(2)
are tight.
8.
If applicable, return strainer grids to strainer connectors inside pool after removing
black hat-like plugs that prevented water from flowing out of the pool.
9.
Connect the electric pool heater to the power outlet. Test RCD as shown on following
page.
10.
Turn pump on. Check water is flowing through the heater. Then turn heater on.
IMPORTANT
If the heater is not in an upright position a safety switch will automatically turn
the heater off. Be sure the heater is always in an upright position while the cord
is connected to the power outlet.
