SEPAMAT F_maual_Vers.2.8f
2
1 Introduction and scope of application
Congratulations on purchasing your
SEPAMAT F
.
The
SMT F
is designed as a separation unit, for use in single-family homes, apartment buildings, offices
and industry.
The DVGW certified, fully automatic and ready-to-connect separation unit fulfills the separation of
drinking water from category 5 liquids according to DIN EN 1717.
The integrated pump supplies water on-demand from the separation chamber to the users. The water
level in the separation chamber is controlled by a floating valve. The drinking water supply and
emergency overflow are connected to the separation chamber.
The highest consumer connection point can be a maximum of 20 m above the
SMT F
.
2 Safety
instructions
The live components have to be installed only by a qualified electrician. In case of
failure of the electronic device, the product has to be repaired by a qualified
electrician before being operated again. There is a risk of electric shock!
The outlet circuit used for the device has to be secured through a circuit breaker
protected (16 A in several countries). If unavailable, an FI switch with maximum
operating current of 30 mA has to be connected.
These installation and operating guidelines have to be read carefully before
installing the product. The instructions mentioned have to be followed strictly.
Modifications to the product are not permitted, otherwise the warranty becomes
void.
The following points have to be strictly observed during the installation and operation:
Check the product before installation for any visible defects. If defects are present, then the
product must not be installed. Damaged products can be dangerous.
Installations at the mains water pipeline system have to be only performed by a qualified
installation company.
A floor drain has to be provided near the installation site, which can collect inadvertent water
discharges (i.e. pump defects, pipe breakages, etc.) and prevent water damage inside the building.
The mason work behind the water-handling unit must be protected from water damage (i.e. with
water-resistant coating).
Make sure that the existing emergency overflows are connected and adequately sized.
Remove the mains electrical plug if you will be away for more than 24 hours.
Close the mains water line at the inlet of the device if you will be away for more than 24 hours.
All products must be regularly inspected to maintain proper condition. The minimum inspection
interval is mentioned in the maintenance section.
Electrical devices may be hazardous for children. Therefore children always have to be kept away
from the product. Do not let children play with the product.
