SEPAMAT F_maual_Vers.2.8f
16
7 Start-up and use
7.1 Start-up in mains water mode
1. Check that all lines are connected. Select maintenance
mode =
Switch position II.
2. Open the mains water line stopcock so that the separation
chamber is filled with water.
Note:
In maintenance mode the pump primed with water
automatically over the mains water tank. In this case the
pump cannot be manually filled with water!
3. Close the pressure line shut-off valve.
4.
Open the air vent (hold a bucket of water under the air vent)
and start the pump by plugging in the mains power.
Let the water run from the air vent into the water bucket
until there is no more sign of bubbles (a clear stream)
meaning that all air has been removed from the suction
line.
5. Close the air vent.
