IntesisBox
®
Modbus Server
– Modbus RTU Master
User’s Manual r1 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
12 / 15
Modbus TCP configuration:
Figure 5.2
Modbus TCP interface configuration.
IP IntesisBox:
Enter the IP address for IntesisBox.
Net Mask:
Enter the IP net mask for IntesisBox.
Gateway:
Enter the default router address to use by IntesisBox, leave blank if there is
no need of router address.
Port:
Enter the TCP port to use, by default 502.
Timeout Keep Alive:
Enter the Keep Alive Timeout (in seconds). This is the time
without Modbus TCP traffic after which IntesisBox will send a Keep Alive packet to the
master(s) connected to it; this is to maintain alive the TCP connection.
Modbus RTU configuration:
Figure 5.3
Modbus RTU interface configuration
Connection:
Select the port to use (EIA232 or EIA485).
Data Bits:
Data bits
Baud rate:
Select the baud rate to use
Parity:
Select the parity.
Slave:
Enter the Modbus slave number for IntesisBox.
