IntesisBox
®
Modbus Server
– Modbus RTU Master
User’s Manual r1 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
10 / 15
In case there is no communication with the IntesisBox IntesisBox, check that the Modbus
TCP devices they are operative and reachable from the network connection used by
IntesisBox. Check the IntesisBox Ethernet interface sending Pings to its IP address using a
PC connected to the same Ethernet network.
4.4 Connect to PC (LinkBoxMB)
This action allows the user to have access to configuration and monitoring of the device
(more information can be found in the LinkBoxMB User Manual [section 5]).Two methods to
connect to the PC can be used:
Ethernet: Using the ETH port (Figure 4.1) of IntesisBox. How to check connectivity is
explained in section 4.3.
Serial cable: To connect the device to the PC the serial cable supplied should be
plugged to the PC console port (Figure 4.1).
The cable is an EIA232 straight cable and its pin out is at explained in Table 4.2.
IntesisBox
PC
DB9 M
EIA232 (Straight)
DB9 F
TX
2
2
RX
RX
3
3
TX
GND
5
5
GND
Table 4.2
Configuration serial cable pin out
