IntesisBox
®
ASCII
Server - BACnet
IP
User manual v10 r15 eng
Doc: IntesisBox ASCII Server - BACnet IP client v10 r15 eng.pdf
© Intesis Software S.L.U. - All rights reserved
IntesisBox
is a registered trademark of Intesis Software SLU
URL
tel
http://www.intesisbox.com
[email protected]
+34 938047134
Page 19 of 36
ASCII interface configuration parameters:
ASCII interface Configuration
1.
Enter the timeout (in 0..2000 milliseconds) to wait for consecutive spontaneous frames.
2.
If set active, after a successful write message from ASCII is received, the gateway will
send an
>OK\r
frame.
3.
Select the type of ASCII port used: ASCII over EIA-232 (serial connection) or ASCII over
Ethernet (TCP/IP connection). (Both ASCII ports cannot be used simultaneously)
4.
Enter the baud rate to use. (The rest of parameters are fixed: 8-N-1).
5.
Enter the ASCII port number to use for ASCII over Ethernet (TCP/IP).
6.
Enter the “Time without activity” (in 0..65535 seconds) to send the “Keep Alive” packet,
if set to “0” this function is disabled (no packet will be send).
7.
Select the gateway model used: Basic or Extended. You can check the gateway model in
the identification given by the gateway when it connects to LinkBoxBacnet, it appears in
the IntesisBox Communication Console window after clicking on the
Online
checkbox, it
is something like this:
IntesisBox_Bacnet_IP_ASCI-INT-
A
…
-> this is the Basic model (up to 500 internal
points)
IntesisBox_Bacnet_IP_ASCI-INT-
B
…
-> this is the Extended model (up to 4000 internal
points)
2
3
4
1
5
6
7
