background image

 

  

Thank you for choosing the Heat Pure 1500 Infrared Zone Heating System. This owner’s manual 
will provide you with valuable information necessary for the proper care and maintenance of 
your new product. Please take a few moments to thoroughly read the instructions and familiarize 
yourself with all the operational aspects of your new heater.  

 
 

IMPORTANT INSTRUCTIONS 
 

When using this electric unit, basic safety precautions should always be followed to reduce the 
risk of fire, electric shock, and injury to persons, including the following: 

 
1.

 

Read ALL instructions before using this unit. 

2.

 

CAUTION: Risk of Electric Shock. DO NOT open or try to repair the heater yourself. 

3.

 

This heater may get hot when in use. To avoid burns, DO NOT let bare skin touch hot 
surfaces. If provided, use handles when moving this heater.  

4.

 

Keep combustible materials, such as furniture, pillows, bedding, paper, clothes, and 
curtains at least 3 ft from the front of the heater and keep them away from the sides, top, 
and rear. DO NOT place towels or other objects on the heater.  

5.

 

Extreme caution is necessary when any heater is used by or near children or the disabled, 
or when the heater is left operating and unattended. 

6.

 

DO NOT operate any heater with a damaged cord or after the heater malfunctions, has 
been dropped or damaged in any manner. Return heater to authorized service facility for 
examination, electrical or mechanical adjustment, or repair. 

7.

 

This heater is not intended for use in bathrooms, laundry areas and similar indoor 
locations. NEVER locate heater where it may fall into a bathtub or other water container. 
To protect against electrical hazards, DO NOT immerse in water or other liquids.  

8.

 

DO NOT touch the control panel or plug with a wet hand.  

9.

 

DO NOT run cord under carpeting. DO NOT cover cord with throw rugs, runners, or 
similar coverings. Arrange cord away from traffic area and where it will not be tripped 
over. 

10.

 

DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as 
this may cause an electric shock or fire, or damage the heater. 

11.

 

To prevent a possible fire, DO NOT block the air intakes or exhaust in any manner. DO 
NOT use on soft surfaces, like a bed, where openings may become blocked.  

12.

 

A heater has hot and arcing or sparking parts inside. DO NOT use in areas where 
gasoline, paint, explosive and/or flammable liquids are used or stored. Keep unit away 
from heated surfaces and open flames. 

13.

 

Avoid the use of an extension cord because the extension cord may overheat and cause a 
risk of fire. However, if you have to use an extension cord, the cord shall be No. 16 
AWG minimum size and rated not less than 1500W.  

14.

 

To avoid fire or shock hazard, plug the unit directly into a 115 V AC electrical outlet. 

15.

 

To disconnect heater, turn controls to OFF, then remove plug from outlet. Pull firmly on 
the plug, DO NOT unplug by pulling on the cord. 

Summary of Contents for ATI-HPE-XPW











Reviews: