Intertek 990-3075 Manual Download Page 6

 

 

 

Important safety instructions 

 

When using this electrical appliance, basic precautions must be followed to reduce the risk 

of fire, electric shock, and injury to a person, including the following 

 

 

 

 

Do not switch the appliance ON until it is properly installed as described in this 

manual.

 

 

Do not leave the appliance unattended during use. 

 

Keep out of reach of children and do not allow them to operate this appliance. 

 

From time to time, check the cord for damage. Never use the appliance if the cord or 

any part of the appliance shows signs of damage. 

 

Repairs to electrical appliances should only be performed by a qualified electrician.   

Improper repairs may place the user at serious risks. 

 

Do not run the cable under carpets, rugs etc. 

 

Do not allow the mains cable to hang over sharp edges or come into contact with hot 

surfaces. 

 

WARNING: In order to avoid overheating, do not cover or obstruct the heater in any 

way. 

 

Never immerse the product in water or any other liquids. 

 

 

LED Bulb Replacement 

Note: The flame effect of this electric fireplace is created by LED Bulbs. 

The life of these LED bulbs will be 100 000 hours. The users are not recommended to 

replace the LED Bulbs. For any reason should the bulbs stop working properly, contact a 

qualified technician. 

 

 

 

-9- 

 

 

Cleaning:

 

 

Turn the heater OFF and unplug from the electrical outlet before any cleaning or 

maintenance is performed. Wait at least 10 minutes to allow all components to cool 

down properly. 

 

Use a vacuum or duster to keep the heater and the vent area clean from dust and dirt. 

 

The exterior of the fireplace should be cleaned with a damp cloth or a duster. 

Do not use abrasive cleaners or liquid sprayers. 

 

WARNINGS AND CAUTIONS 

WARNING :   

To avoid electrical shocks, do not open the back panel of the element

 

unless the power has been turned off and unplugged. 

WARNING :

   Any electrical repairs to this electric fireplace should be   

                         performed by a qualified technician. 

WARNING 

:   Any electrical wiring repairs should only be performed by a qualified   

                         technician and must comply with local buildings codes. 

WARNING : 

Discontinue use of this electric fireplace if any of the following has 

occurred : Water damages, if the element is dented, if the power cord is 

broken, if power cord becomes hot to touch, if unit smokes or   

                         smells like smoke. 

 

Note:  When the heat function is used for the first time, a slight odor may be   

 present. This is normal and should not occur again, unless the heater is not 

used for an extended period of time and that dust is allowed to accumulate 

on the heater element.           

                                                                                                                             

                                                   

Technical specification 

 

Supply : 120V/60Hz 

 

Rated power :750W/1500W 

 

 

 

-10- 

Summary of Contents for 990-3075














Reviews: