17
3. With the Presenter Control button on the front panel in the required starting
state (see Fig 4), press and hold the presenter control button. After about 6
seconds the visual display will cycle through the three handset button
programming points:
Green only on the right of the display (NEXT button command point)
Red only on the left of the display (BACK button command point)
Amber (BLACK button command point)
4. Releasing the Presenter Control button at any of these points will leave the
system ready to receive a new command for that particular button on the
handset.
5. Once the system is ready to receive a new command for the button you
wish to re-program, press the key/s on the keyboard to simulate the
command you require (e.g. press the letter ‘w’ to make the screen go to
white)
6. Press the Presenter Control button once more momentarily to store the new
command.
7. Repeat this procedure to program each of the three handset buttons as
required.
8. To program a different USB channel, start with the presenter control button
in the required alternative state (see Fig 4), then repeat the entire
procedure from 1 above.
