Preliminary User manual
FCC ID: OSZ37704C
Page 8 of 10
2-Regulatory information
2.1 FCC Information to User
This product does not contain any user serviceable components and is to be used with approved
antennas only. Any product changes or modifications will invalidate all applicable regulatory
certifications and approvals
2.2 Product Compliance
This Indigo device complies with the standards as shown in table below:
country Approval
specification
notes
USA
FCC part 15, sections 15.107, 15.109, 15.207,
15.209, 15.407
Tested at accredited laboratories
and filed for FCC certification.
European Union
EN 301 893 V1.1.1 (2001-01)
ETSI EN 301 489-1 V1.3.1 (2001-07)
ETSI EN 301 489-17 V1.1.1 (2000-09)
EN60950 incl A1, A2, A3, A4
Tested at accredited laboratories
and Notified according to article 6.4
of the RTTE directive
Japan
ARIB STD T71 v.1.0, 14 december 2000
Tested at TELEC laboratories and
filed for MPT Japan certification.
Table 02: Compliance specifications
2.3 USA-FCC (Federal Communications Commission) statement
This device complies with Part 15 of FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause interference, and
2.
this device must accept any interference, including interference that may cause undesired
operation of this device.
2.4 FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance
with the instructions, it may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
1.
Reorient or relocate the receiving antenna.
2.
Increase the distance between the equipment and the receiver.
3.
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
4.
Consult the dealer or an experienced radio/TV technician for help.
