Interpump GREEN JET GX22, Operating Instructions Manual, Page: 10 / 116

10
4.2 - IDENTIFICATION LABEL
Before using the machine, make sure that it is provided with
the identification label. In case the identification label is
missing, do not use the machine and consult your dealer imme-
diately.
The identification label with the technical specifications is fixed
to the machine.
Check that ID label specifications correspond to those required
and that the power characteristics for the outlet (V/Hz) are those
shown on the label.
5.1 - HIGH PRESSURE CONNECTION
If the user wishes to power the washer by means of free suction, simply emerge the end of the
supply tube in the water to be suctioned. The maximum suction depth considered as the dis-
tance in height between the water surface and the pump is 1 m.
IMPORTANT
Make sure that the machine is fed with clean water during use.
Running the machine without water, or with dirty, sandy water or containing corrosive
chemicals, causes serious damage to the machine.
1. Insert the lance in the gun and turn the nut to tighten it safely (A).
2. Connect the high pressure hose to the OUTLET port (B) and tighten the nut.
5.2 - CONNECTION TO WATER SUPPLY
1. The maximum temperature of the inlet water must not exceed 60°C (140°F).
2. Connect the water supply to the INLET port by means of a reinforced hose (minimum
15 bar/1,5 Mpa/200 psi) with internal diameter of no less than 13 mm (1/2”).
3. Considering that the water flow decreases in accordance with the length of the hose,
make sure that the quantity of water reaching the machine is at least 10 lpm.
4. The pressure of the inlet water must not exceed 10 bar, 1 MPa, 145 psi.
ATTENTION: The water supply which enters into the washer is not drinkable.
5 - INSTALLATION