Interpump BOXJET TURBO 11.50, Operating Instructions Manual

Page: 12 / 138

10
5.3 - CONNECTION TO ELECTRICAL SYSTEM
1 - Check that the voltage of the electrical system (mains) is the same as indicated on the ID
label of the machine.
2 - Check that the plug complies with local safety regulations, and that it is provided with
ground connection (earth).
3 - Ensure that the outlet is protected by a "cut-out" (differential magnetic-thermal switch with
sensitivity of less than 30mA per 30ms) or that a device is present which can test the earthing
circuit.
4 - Do not connect other appliances to the same power outlet while using the machine.
5 - Insert the plug only after checking that the machine switch is in the OFF position.
6 - The standard plug for 50 Hz versions: SCHUKO 250V - 16A, standard CEE7-VII
DIN49441-2-AR2.
7- Fully unwind the power cord to prevent overheating.
8 - Do not crush on the power cord.
9 - Do not use the high pressure cleaner if the electric cable is damaged.
10 - If the power cord is damaged, its replacement can be effected only by the technical ser-
vice personnel or by a qualified technician.
WARNING: IN CASE OF POWER FAILURE DURING OPERATION TURN OFF THE
UNIT FOR SAFETY REASONS.
5.3.1 - CUT-OUT SWITCH (Only the United States)
This UL version high-pressure washer is equipped with a cut-out switch contained in the power
cable plug.
Said equipment provides extra protection against the risk of electric shock.
When replacing the plug or cable, use the same components including the cut-out device.