9
User Manual
1. Radar Installation
This chapters illustrates the instructions on electrical connections of the Radar
and the necessary software settings to operate it.
WARNING
In order for the Radar to communicate with the Chart Plotter, the software
configuration explained in the Par. 1.5 is mandatory.
1.1
PRELIMINARY
The scanner unit must be located so that passengers and crew are not exposed to
the direct radar beam. The scanner unit should be mounted on the centerline of
your vessel in a location that has an unobstructed view forward and is as clear as
possible the rest of the way around the unit. A location as high as practical to
improve maximum range is preferable, keeping in mind that minimum range ob-
jects may be overlooked if mounted too high. Place the units in before large
structures and exhaust stacks. Large structure or stacks cause blind spots. Con-
tamination from engine exhaust on the scanner housing reduces radar perfor-
mance.
Antennas for GPS, radio communication or other equipment should not be in the
radar beam. Use non-metallic extension poles to move the active area of anten-
nas above the radar beam.
In selecting a location, consider the suitability of the mounting surface. It must be
flat and approximately levelled with the vessel’s water line. The surface must
support the weight of the scanner and have access to the under side for installa-
tion of the four mounting bolts.
NOTE
The recommended mounting surface thickness is 3/8 to 1/2 in. (9 mm to 13 mm).
The scanner will be damaged if bolts penetrate more than 9/16 in. (15 mm).
Also, consider the cable route from the scanner to the operator’s location. Avoid
routing the interconnecting cable through areas of possible damage from moving
objects, machinery, and exposure to chemicals or high temperature.
1.2
PREPARATION
Unpack your new RADAR and check that the contents correspond to the packing
list. Do not remove the cover from the unit. There are no connections or adjust-
ments inside the unit that are needed for installation or operation. The cable must
remain attached. For ease of handling, coil the cable and place it on top of the
scanner. Then secure it with tape. Invert the scanner and make sure the four
mounting holes are clear to accept bolts.
Working at higher elevations may become necessary while installing the scanner
unit. Observe safety measures and take sufficient precaution to avoid personal
injury or damage to the equipment.
1.3
PROCEDURE
♦
Prepare the mounting surface by making sure it is clean and flat.
♦
Use the template provided to mark the location of four mounting holes.
Align the template squarely with the centerline of the vessel and with
the arrow pointing forward.
