Example 1:
<SOH>A,5,46180,<STX>This is a test<ETX><EOT><SOH><ACK>V8.01,00,0,1,1A<EOT>
Echoes the paging message command and acknowledges proper receipt of a command by appending the
ACK
, indicating paging encoder firmware version is 8.01, no paging messages in queue, no carrier signal
is being detected, and
Carrier Detect
mode is set to
“ON”
. The last field does not currently provide useful
information.
Example 2:
<SOH>4,5,0000006<EOT><SOH><NAK>03<EOT><CR><LF>
Echoes the paging message command and indicates an error in receiving a command due to an invalid
paging receiver capcode in a Paging Message command. Includes a
<CR>
and
<LF>
at the end of the
response string if they were included in the paging message command.
SETUP COMMAND
You may program the
InterPage
Z-500 Series
Paging Encoders
to monitor for interference using the
Carrier Detect
mode. If the
Carrier Detect
mode is turned
“ON”
, the paging encoder will hold paging messages in queue until an
offending carrier signal is no longer detected at the transmission frequency of the paging encoder. The settings
programmed by the Setup command will be remembered by the paging encoder even if power is removed from the
paging encoder.
The Setup command is formatted as follows:
<SOH>S,X,V<EOT>
Where the S indicates Setup Mode,
X
is the command type, and
V
is the value. The comma delimiters are
optional.
X
A single numeric value used to indicate the command type. The numeric character is followed by a
comma.
Valid values
(X)
are:
1 =
Carrier Detect Mode
V
A single numeric value used to indicate the value of the command setting to be saved. The
numeric character is followed by an
EOT
character.
Valid values
(V)
are:
0 =
Off
1 =
On
WaveWare Interface Continued on next page…
