950-0139
7/21/2009
- 4 -
o
The outdoor unit should be placed on a condenser pad.
o
If
it’s a heat pump it must be raised up approximately 4'' to allow for
connections and defrost to drain away.
o
Do not install the outdoor unit in a location exposed to high winds (field
fabricated and installed wind baffle may be required).
o
Ensure location does not impede access around the unit and/or pose a
disturbance to neighboring areas.
Mounting indoor bracket:
o
After unpacking remove mounting bracket from the rear of the indoor unit.
o
Locate an area to mount bracket.
o
Use a level to ensure mounting bracket is level so condensate will drain
properly.
o
The indoor unit weighs a maximum of 46 lbs.
o
Securely attach bracket to the wall by placing screws through the bracket
into the wall studs.
o
Check that the wall is steady and capable of holding the weight of the
indoor unit.
Mounting bracket
Heat pump models must be
mounted with a minimum of 4
”
clearance to allow for drain
connections. Plasti-Duct floor
supports work well for this
application.
condensation to drain away