6051344
Rev. 1.0
Page 10 of 17
Step 5: Changing the 212iLM Mullion Feedback Options.
The 212iLM Mullion has two keypress feedback options that you may choose from. One is an audio feed
back. This will activate the on board sounder every time that a key is pressed. The other is a visual
feedback. This will flash the yellow LED on the front of the keypad every time that a key is pressed.
These two options are used to verify when a key has been pressed. Both of these options may be used
individually, together or not at all. They are enabled by default.
Audio Option:
Enter Programming Mode: 99# (Master code)
*
Next press Command number 30 followed by the # key.
Next press "0" for the audio feedback option followed by the # key.
Next press "0" to Disable or "1" to Enable the audio option followed by the # key.
Next press the
*
key (Yellow LED flashes rapidly).
Next press the
*
key (Yellow LED will flash slowly).
Example: 30 # 0 # 0 #
*
*
(This will disable the sounder from activating every time a key is pressed).
Example: 30 # 0 # 1 #
*
*
(This will enable the sounder to activate every time a key is pressed).
Continue programming or press the
*
key again to exit.
Visual Option:
Enter Programming Mode: 99# (Master code)
*
Next press Command number 30 followed by the # key.
Next press "1" for the visual feed back option followed by the # key.
Next press "0" to Disable or "1" to Enable the visual option followed by the # key.
Next press the
*
key
(Yellow LED flashes rapidly).
Next press the
*
key (Yellow LED will flash slowly).
Example: 30 # 1 # 0 #
*
*
(This will disable the yellow led from activating every time a key is pressed).
Example: 30 # 1 # 1 #
*
*
(This will enable the yellow led to activate every time a key is pressed).
Continue programming or press the
*
key again to exit.
Step 6: Auto-Entry.
Auto entry is used to turn off the star
*
key. The user only needs to enter their code number without the
star key and the relay will activate for the programmed relay time. To use this feature, the user codes
must be the same length as the Master code. This feature is disabled by default.
Enter Programming Mode: 99# (Master code)
*
Next press Command number 30 followed by the # key.
Next press "2" for the Auto-Entry option followed by the # key.
Next press "0" to Disable or "1" to Enable the Auto-Entry option followed by the # key.
Next press the
*
key
(Yellow LED flashes rapidly).
Next press the
*
key (Yellow LED will flash slowly).
If the change was successful, the yellow LED will still be flashing slowly.
Example: 30 # 2 # 1 #
*
*
(This will remove the
*
key from the code).
Example: 30 # 2 # 0 #
*
*
(This will add the
*
key to the code).
Continue programming or press the
*
key again to exit.
