INTERNATIONAL CARBONIC PF-2-PB Installation Manual Download

Page: 2 / 8

SPECIFICATIONS:

* Weight ...................................................................................... 1 lb 4 ounces
* Height ....................................................................................... 5” with Nozzle
* Depth........................................................................................ 4”
* Width ........................................................................................ 2 ¼”
* Electrical Requirement ............................................................. 24 VAC

Upon receiving valve unpack and inspect for shipping damage. If damage is
found, notify shipping agent immediately. At this time, inspect for any missing
parts and if parts are missing notify factory.

The PF-2-PB has been designed to fit in place of any existing FT, FT-II, PF or
PFC-II valve. On International Carbonic Inc. equipment no modification of
existing valve plates will be necessary. If valve is to be mounted on other than
International Carbonic Inc. equipment notify factory for required template.

TO CONVERT AN EXISTING SINGLE FLAVOR UNIT TO A TWO FLAVOR
VALVE:

1. Shut off CO2, and water, then disconnect syrup from valve to be

converted.

2. Disconnect electrical supply to unit to be modified, either at electrical

outlet or valve key switch.

3. Install additional syrup cooling coil in the water bath system or plumb into

extra syrup cooling pass on cold plate systems to obtain necessary
cooling. Note: In some juice applications cooling the syrup will not be
necessary.

4. Remove

existing
standard
valve and
replace with
PF-2-PB.
All PF-2-PB
valves have
alignment
pins, see
illustration.
These
alignments
pins may

not fit on older valve mounting plate. If that is the case the alignment pins
may be removed with a sharp knife. Align valve body with mounting plate
and attach with supplied valve mounting screws.

Mounting Plate Hole

REAR VIEW

Alignment Pin

Inlet Screw Hole

Syrup #1

Syrup #2

Water