6-Pin PRPC Connector Pin-Out Definition
Connector J18 contains 6 of the PRPC’s 11 fused output pins. These 6 fused output pins are
connected to 4 configurable relay outputs. Each relay output is capable of 15 Amps maxi-
mum. Configurable relay output 4 is shared by fuses 4A, 4B, and 4C. When added together
the sum of these three fuses must not exceed 20 Amps. Note that the placement of fuse 3
will determine whether the output is active high or active low. The use of fused outputs 4A,
4B, or 4C is recommended for higher current loads.
The PRPC module has an absolute
maximum current rating of 65 Amps.
The 6 fused output pins on connector J18 are defined as follows:
•
Pin #1 (White wire) Configurable Relay Output 4, Fuse 4C, Active High
•
Pin #2 (White wire) Configurable Relay Output 4, Fuse 4B, Active High
•
Pin #3 (White wire) Configurable Relay Output 4, Fuse 4A, Active High
•
Pin #4 (White wire) Configurable Relay Output 3, Fuse 3,
Fuse Selectable Active High/Low
•
Pin #5 (White wire) Configurable Relay Output 2, Fuse 2, Active High
•
Pin #6 (White wire) Configurable Relay Output 1, Fuse 1, Active High
Connect the desired outputs to vehicle equipment as needed. Tape up unused leads.
6 Pin Output
Back of Connector
InterMotive Inc.
13395 New Airport Rd.
Auburn, CA 95602
Phone: (530)-823-1048
Fax: (530)-823-1516
Page 6 of 13
www.intermotive.net
PRPC501-A-090314-INS
The default configuration for the relay outputs on J18 are as follows:
•
Pin #1 (White wire),
•
Pin #2 (White wire),
•
Pin #3 (White wire),
•
Pin #4 (White wire), Left Turn Signal On
•
Pin #5 (White wire), Key On
•
Pin #6 (White wire), Low Beams or High Beams
2-Pin PRPC Connector
Connector J20 contains the two black ground wires for relay output fuse sensing,
motor reversing, and low true relay outputs. This is not an optional connection. The
wires in this connector must be attached to a good chassis ground for the system to
function properly.
1
2
3
4
5
6
Right Turn Signal On
