Chapter 2 — Scanning With the SR61T
SR61T Tethered Scanner User’s Guide
17
To scan a bar code label with a laser scanner or 1D linear imager
1
Point the SR61T at the bar code label and hold the SR61T at a
slight angle 15 to 25 cm (6 to 10 in) from the label.
2
Pull the trigger, and direct the red beam so that it falls across all
bars in the bar code label.
Use this test bar code:
Code 39 Test Bar Code
*123456*
Tip:
Depending on your screen resolution, you can scan bar codes
displayed on your computer screen except when scanning with the
SR61TL (laser imager). Print out and scan bar codes with the
SR61TL (laser imager).
When the SR61T successfully reads a bar code label, the SR61T
beeps one time, the status light briefly turns green, and the
scanner beam turns off. If Vibrate Alert is enabled, the SR61T
briefly vibrates.
3
Release the trigger.
Scanning Bar Codes:
The aiming and scanner beams that you see depend
on which SR61T model you are using.
ABCD
Status light
ABCD
ABCD
Summary of Contents for SR61T
