![background image](http://html1.mh-extra.com/html/interlogix/tvp-6101/tvp-6101_installation-manual_2077192016.webp)
12
Installation Guide
DIP switch settings including selecting
HD-TVI or Analog output
HD-TVI PTZ
For pendant/wall PTZ cameras, access the D
IP switch by
removing the rubber plugs on the two sides of the PTZ
housing and unscrewing the two screws inside. Then open the
bubble assembly, remove all three foam inserts and the plastic
protective lens cover (see Figure 1).
For surface/flush PTZ
cameras, access the DIP switches by
rotating the housing (see Figure 2).
Use the DIP switch to set the address and baud rate for the
PTZ. Value ON=1 and OFF=0.
Use t
he SW1 switches fr
om the first to the eighth positions to
set the address. Use the
SW2 switches to set the baud
rate.
Note:
The default dome address is 0. The default baud rate is
2400.
Figure 1: DIP switch location for pendant/wall mount PTZ
DIP switch
Summary of Contents for TVP-6101
Page 37: ...Installation Guide 33 3 Locate the two pins near the corner of the dome drive base ...
Page 56: ...52 Installation Guide ...
Page 59: ......
Page 60: ......