2
TruVision High Definition TVI Camera Configuration Manual
Introduction
This is the configuration manual for following camera models:
TVB-2402
(720P TVI Bullet Camera, VF Lens, IR, PAL)
TVB-4402
(720P TVI Bullet Camera, VF Lens, IR, NTSC)
TVD-2402
(720P TVI Mini Dome, VF Lens, IR, PAL)
TVD-4402
(720P TVI Mini Dome, VF Lens, IR, NTSC)
Programming
Once the camera hardware has been installed, the camera can then be
configured using the built-in OSD button or an OSD controller (purchased
separately).
You can also configure the camera settings via a TVI DVR, select PTZ protocol
as TruVision Coax and click the menu button to call the menu.
Note:
Interlogix offers two different versions of the OSD Controller: the TVS-C100
controller and the TVS-C200 controller. Please choose the corresponding
controller by referring to product datasheets.
The cameras listed in the “Introduction” section support TruVision Coax OSD
control protocol and require the TVS-C200 for OSD control.
The TVS-C200 is used to program the camera’s 960H CVBS output, not for the
TVI video output. Programming the camera’s TVI output can be done via a TVI
DVR.
The TVS-C200 has four buttons for the camera functions selection and control.
Table 1 below lists the OSD control button functions and describes their use.
