3.
Route the camera cable harness through the cable
access hole on the junction box and tighten the
waterproof nut.
Note
: Insert the PoE cable or BNC cable first, followed by
the RS
-485 wires, audio input and output wires, alarm
input and output wires, and power supply wires. For the
power supply wires, the red plastic interface must first be
removed.
4. If the other three cable access holes are used, unscrew
the hex bolt and remove the pre-installed black solid
sealing plug.
5. Choose the applicable sealing plug from the white, blue,
and black sealing plugs according to the diameter of the
cable.
6
.
Route the cable through the sealing plug (1), flat washer
(2) and the hex bolt (3) and tighten to maintain IP67
rating.
14
Installation Guide