4. Connect the four-conductor’s green and red wires to the
protector block’s TIP (+) and RING (-) posts (see
D
in
Figure 6 below).
Figure 6: Connecting an RJ-31X jack to a home phone line
BRN
GRY
GRN
RED
DE
R
ETI
H
W
R
O(
)
W
OL
LE
Y
BLAC
K
GREEN
RED
RING
(-)
GREEN
RED
TIP
(+)
RJ-31X
JACK
GREEN
BLACK
WHITE (OR YELLOW)
A
B
C
D
Telco Protector
Block
RJ-31X
Phone Line
Wire Run
Home
Phone
Lines
Wiring Connections for Concord Panels
Wiring a Concord system requires you to wire for power, bus,
speaker, and phone lines. Refer to the figures shown below for
wiring designated partitions.
Caution:
To prevent damage to the panel, or module, remove
the panel’s AC power transformer and disconnect the backup
battery prior to wiring.
Wiring - Power and Bus
All partitions
Figure 7: Wiring the PIV module to panel power and Bus terminals
Panel Terminals
Phone Interface/Voice
Module Terminal Strip 1
Phone Interface/Voice
Module Terminal Strip 2
Wiring - phone line
Note
: All partitions must be wired to separate phone lines.
Partition 1
Figure 8: Wiring the PIV module to a phone line (partition 1)
Phone Interface/Voice
Module Terminal Strip 1
Phone Interface/Voice
Module Terminal Strip 2
DB-8 Cord
Plug
All other partitions
Figure 9: Wiring the PIV module to a phone line (all other
partitions)
Phone Interface/Voice
Module Terminal Strip 2
DB-8 Cord
Plug
Wiring - speakers
Note
: Do not connect speakers to the panel if terminals 7 and
8 are connected to PIV terminals 8 and 9 ( see Figure 10 on
page 5).
4
SuperBus 2000 Phone Interface/Voice Module Installation Instructions