Chapter 1: Installation
10
CDC4 Door Controller Installation and Programming Manual
Figure 8: Tamper mount
Mounting devices
The enclosure is pre-cut to support various devices. Each device is supplied with
stand-offs to be located within the enclosure.
Refer to “Mounting locations” below to identify where the standoffs should be
installed to support the device.
1. Insert the standoffs by squeezing the legs together and inserting the standoff
into the square hole. Allow the standoff to spring back into shape to grip the
enclosure.
2. Remove the device from its antistatic bag.
3. Use the M3 screws supplied with the device to fasten it to the standoffs.
Mounting locations
A few examples of various size devices mounted in the housing are shown in the
following figures.
Summary of Contents for CDC4
Page 1: ...CDC4 Door Controller Installation and Programming Manual P N 466 5478 REV D ISS 29OCT19 ...
Page 86: ...Chapter 3 Programming 80 CDC4 Door Controller Installation and Programming Manual ...
Page 120: ...Chapter 4 Menu reference 114 CDC4 Door Controller Installation and Programming Manual ...
Page 136: ...130 CDC4 Door Controller Installation and Programming Manual ...