4 / 7
P/N 1073502A
• REV 00.00 • ISS 4JUL18
Edit reader properties and click
“Save” button.
Check at event table if the configuration was successful.
Delete reader
Right-click on the reader and select
“Delete” reader
ADD user
1. Open the
“Users Window” and create a new user.
Click on “New User”, put a name and ID (card number).
2. Select the reader (with left click) from which the enrollment
will be done.
3. Right click on the fingertip and select enroll.
4. Place the finger on the reader and fingertip will turn red,
orange or green, with percentage of successful enrollment
shown next to the fingertip.
In these 25 sec. the reader will continuously blink.
5. Repeat point 4 & 5 for each finger that should be enrolled.
6. Click on “Save New” and the fingerprint
will be sent
automatically
to all biometric readers where that user has
access, i.e. to all the readers according to the Access Level
assign to that user.
Example:
If the user has “Unlimited” Access level then the fingerprints
will be sent to all readers, if the user has Access level only for
Reader 1 and Reader 3 then the fingerprints will be sent only
to those two readers.
Note:
To check if all the fingerprints are sent to the reader, right click
on the reader and select “Memory Status”.
