Interline 59695325, Instruction Manual

Page: 26 / 81

3.Installation
The factory only provides the heat pump unit; the other items including an eventual bypass, in
the illustration are necessary parts for the water system, provided by users or the installers.
Attention:
Please follow these steps when installing the heat pump:
1. All feeding of chemicals to the pool water has to be done downstream of the heat pump.
2. Install a bypass when the flow of the pool pump is more than 20% above the rated flow of the
heat exchanger of the heat pump.
3. Install the heat pump above the level of the pool water.
4. Install the heat pump on a solid foundation and use the damping rubbers to eliminate vibrations and noise.
5. Always keep the unit straight up. If the unit has been tilted or put on his side, allow 24h before starting the
unit.
3.1 Heat pump location
The unit may be installed virtually anywhere outdoors. For indoor pools please consult your suppliers.
DO NOT put the unit in an enclosed area with a limited air volume where the unit discharge air will be re-
circulated. DO NOT put the unit next to shrubs, which can block the air inlet, Such locations deny a continuous
source of fresh air, which reduce its efficiency and may prevent adequate heat delivery.
The picture below give the minimum required distances from each side of the heat pump.
1000mm Above 1000mm Above
Top 2000mm Above
Inlet Inlet
Outlet
Heat
pump
1000mm Above
1000mm Above
Inlet Inlet
Inlet
1000mm Above
Top 1000mm Above
3.2 How to close to the pool
Install the heat pump as close to the swimming pool as possible to minimize the loss of heat through the piping. Put it on
a solid base and place the rubber blocks under the heat pump to eliminate vibrations.
3
4
EN