Intergraph RealiZm Graphics V25, Hardware User'S Manual

Page: 35 / 84

23
NOTE For proper operation, you must install DIMMs of the same memory size, and you must fill both
sockets.
To install texture memory:
1. Remove the Z13, Z25, or V25 board from the system. Refer to “Replacing Z13, Z25,
V25, or Geometry Accelerator” later in this chapter for instructions.
2. Place the board on the antistatic foam pad for protection and support.
CAUTION Failure to use the antistatic foam pad could cause damage to the board.
3. For a Z25 or V25 board, remove the DIMM access cover.
4. Remove a DIMM from its static protective bag.
CAUTION Do not bend, twist or drop DIMMs. They may be damaged as a result.
5. Align the DIMM notches with the keys in one of the texture memory sockets on the
board, and insert the DIMM into the socket. Refer to the following figure.
Texture
Memory
Sockets
DIMM
Access
Cover