PEX-400111
Chapter 2 Factory Default Settings
2.1 Factory Default Settings
(1)
LED1 RSW1
ISP1
B
A
ISP0
B
A
CN1
(2)
(3)
(4)
(1) 68-pin 0.8 mm-pitch female connector (CN1)
This connector connects to external equipment.
(2) Access LED (LED1)
The LED1 glows green to indicate the CPU accesses to this product. A single access lights the LED1
for 500 ms. When continual accesses cease, the LED1 turns off 500 ms later.
(3) Interface module ID rotary switch (RSW1)
The rotary switch on each of our inteface modules identifies each interface module in cases where
our multiple interface modules of the same type are installed in the same system. Remember to set
this switch to a unique setting on each interface module so there is not a conflict among products of
the same type. When using an interface module of the same type, set the rotary switch to “0.”
(Factory default setting: 0)
(4) Reserved switch (ISP0, ISP1)
Setting
Description
B
A
It must be fixed to position A.
Do
not
change the setting.
The
shows the switch setting position.
-
9 -
Interface Corporation
