Polimerizator AQUAMAT GB
6
4.
INSTALATION AND INITIAL START-UP
UNPACKING
•
Carefully remove modules from packages;
•
Make sure that the rated voltage is ~230V and the contact is reliably grounded;
•
Place the device near the power socket, so it is accessible.
CONNECTIONS
•
Connect the main air supply on the rear panel to the nozzle for air (7.). The connecting orifice
is ø6 sized. The maximum pressure in the mains should not be higher than 6 Bar.
•
Connect hose ø8 to the nozzle for exit water (6.) and lead it to the sewage system or to an
outside container for collection of the resting liquid. This orifice is placed on the right-side of
the device.
ATTENTION:
Do not sink this hose in any liquid, because it might destroy the unit!
•
The safety valve is on the rear panel. The unit should be put in a proper place so that if this
valve is activated you are able to avoid the damage of another part. Do not put it on
combustibles.
5.
PRACTICAL USE
PRESETTINGS
The preparation for the work consists in setting of the needed time and temperature. The adjustments
are done using the selection buttons - button
and button
.
After pressing one of these buttons you will see the current value blinking on the display. When the
indication is blinking, you can change it with the help of the arrow buttons until you reach the desired
value.
To save this value you must press the relevant selection button (
or
) again. This way you
exit the mode for adjustment of the parameters and the unit is ready for work.
The polymerization unit has two working temperature zones which means that the device can heat at
two stages. For adjustment of the middle stage the same buttons as described above are used but
they should be kept pressed for more than 2 seconds.
The setting of the middle stage is made in the same way as the final stage. The middle stage cannot
be achieved either if the adjusted temperature is 39°C or if the adjusted time is 0 minutes.
