15
o
Coil Nailer
Drives Plastic Sheet Nails (1¼" to 2½" / 32 to 65mm)
or Wire Weld Nails (1¾" to 2½" / 45 to 65mm)
Model No. CN565-15
Item No. 65555
14
Interchange Brands
Operator’s Manual
Testing The Nailer
Before using the nailer, test it by using the check list below .
If abnormal tests occur, stop using the nailer and contact an authorized service center
immediately .
Conduct the test in the following order .
1 .
Adjust the air pressure to 70 psi and connect the air hose .
2 .
Without touching the trigger, depress the contact arm against the work piece . Pull
the trigger . ﹙The tool must fire the fastener .﹚
3 .
With the tool off the work piece, pull the trigger . Depress the contact arm
against the work piece . ﹙The tool must fire the fastener .﹚
4 .
Adjust the air pressure to the lowest setting possible according to the diameters
and length of fastener and the hardness of work piece .
WARNING!
■
Always follow the tool manufacturer’s safety and
maintenance instructions .
■
Always wear safety glasses with side shields when
operating or servicing tools .
■
Always disconnect the air supply from the tool and empty
the magazine when servicing tools .
!
■
Single Fire
The switch location is shown in
the illustration at the right .
For single fire operation,
depress the contact arm against
the work surface and pull the
trigger . Tool cannot fire a second
nail until the trigger is released
and tool can cycle .
■
Bump Fire (Multi-Fire)
The switch location is shown in
the illustration at the right .
For bump fire operation, hold the
trigger and depress the contact
arm against the work surface .
Turn Switch
to the right
for single fire
operation .
Switch
Turn Switch
to the left for
bump fire
operation .
Trigger
Methods of Operation
Explanation of the two nailing operations
(on some models)
