19
SAMXT User Guide V1.5
AT$UDPCONNECT
If the modem is already allocated an IP address, this command will put the modem in UDP data
mode, the modem DCD pin goes high, data from serial will be packetized into UDP packets and
sent to remote UDP server (UDP settings must be set prior), modem will return to AT Command
mode if it receives no UDP data in 30 seconds.
AT$TCPCONNECT
If the modem is already allocated an IP address, this command will make a TCP client
connection to the remote TCP server, the modem will return to AT Command mode if it receives
no TCP ACK in 30 seconds.
AT$DDNS
Use to setup parameters required for Dynamic DNS updating.
Parameters are defined as:
DDNSENABLE= 0 or 1 (0 disable, 1 enable)
DDNSHOST=Host name
DDNSUSERNAME=DNNS account name
DDNSPASSWORD=DDNS account password
DDNSSERVER=DDNS server
DDNSSTRING: Only need to change from default in some circumstances with Intercel support
DDNSAUTH: Only need to change from default in some circumstances with Intercel support
DDNSAGENT: Only need to change from default in some circumstances with Intercel support
PDNSIP=Primary DNS, leave blank if not using your own DNS server, not a requirement for
DDNS.
SDNSIP=Secondary DNS, leave blank if not using your own DNS server, not a requirement for
DDNS
DNSTTL= DNS Time To Live in minutes before updating of DNS entries, not a requirement for
DDNS.
AT$DDNS=PDNSIP=8.8.8.8,SDNSIP=8.8.4.4,DNSTTL=240,DDNSENABLE=0,DDNSHOST=int
ercelau.ddns.net,DDNSUSERNAME=intercelau,DDNSPASSWORD=123456789,DDNSSERVE
R=dynupdate.noip.com,DDNSSTRING=GET/nic/update?hostname=%s&myip=%sHTTP/1.0,DD
Summary of Contents for SAMXT
Page 1: ...SAMXT User Guide V1 5...
