4. Connection
—
Scape X®
32 AIO
Technical specifications are subject
sx32aio-006
to change without notice.
Operating Manual
Version 1.7 – Status: 05/2020
Page 13 of 26
poc: SFi
4.
Connection
The
Scape X®
32 AIO
is delivered ready for operation. Place the device in a suitable location and connect it to the power
supply.
4.1.
Notes
Observe the following points when setting up the device:
·
Give the
Scape X®
32 AIO
sufficient time to adapt to the ambient temperature. Otherwise the device may be damaged
or destroyed by condensation inside the device.
·
Only operate the
Scape X®
32 AIO
indoors.
·
Do not expose the
Scape X®
32 AIO
to direct sunlight.
4.2.
Connection to the power supply
Connect the
Scape X® 32 AIO
to the power supply via the power supply socket on the underside of the device (see
chapter
2.1 - Connections and controls - point 4
) with the supplied power cable.
To do so, first insert the IEC connector into the appropriate connection and then the plug into the power socket.
When unplugging the unit, always pull the plug rather than the cable.
Do not touch the plug with wet hands.
