Inter-Track IT-E240, User Manual

Page: 7 / 14

Figure 3
4
．
Install the hand-held heart rate tube
Pass the heart rate wire ( 40 ) through the small hole on the back of the upper end of the front bracket (2), and then
pass out from the upper port,Then align the hand-held heart rate tube weldment (5) with the screw hole on the front
bracket (2) , and lock it with two sets of hexagon socket head bolts M 8 ×20 (56), spring washers ф 8 (75) and arc
washers ф 8 (52). (see fig
.
4)
5
．
Installing electronic watch
A.
Connect the heart rate line (40) and the sensing line 2(41) with the corresponding connectors of the electronic watch
(17) and insert the redundant lines into the tube.
B.
Align the hole position of the electronic watch ( 17) with the hole on the instrument panel on the front bracket (2 ).
And locked with four corner bolts M 5 × 12( 90 ). (see fig
.
5)
Figure 4 Figure 5
6
．
Install the left and right swing arm assemblies
Two arc spacers (16) are respectively sleeved on both ends of the swing rod shaft on the front bracket (the arc
mouth is inward), then a wave elastic washer (43) is sleeved on the swing rod shaft on the front bracket (one end of
the long sleeve is inward). Put on plastic flat washer ф 8 (53), large flat pad ф 8 (72), spring washer ф 8 (75), lock
hexagon bolt M8×20(59), and then fasten nut cap (20),At this time, the swing rod should be able to swing freely.
(see fig
.
6)
Figure 6
Metal
Bracket
R esistan ce
cab le
Lo w er
cab le
R esistan ce
cab le
Lo w er
cab le
Lo w er
cab le
R esistan ce
cab le