Inter-m RM-6800, Operation Manual

Page: 10 / 28

SySteM ReMote MIc StAtIon
8
RM-6800
How To Set Up The Device And Precautions
How To Set Up The Device And Precautions
1. BOOT SCREEN: AFTER THE POWER IS SUPPLIED, AN APPROPRIATE DESCRIPTION IS DISPLAYED ON THE
BOOT SCREEN.
- INITIAL SCREEN
1) When power is supplied, the "Booting ... " message will be displayed on the screen after several
seconds.
2) If Factory Reset or the model name you want to use is not designated, the RM Model Set screen is
displayed.
3) the selectable models are RM-6024 and RM-6016, the RM models used in the 6000 System, and nRM-
8000A, the RM model used in the nPX system.
※
nRM-8000A: RM used in the nPX System (cAn communication)
※
RM-6024: RM used to make the 6000 System unified/octuple (RS-422 communication)
※
RM-6016: RM used in the 6000 Analog System (contact control type)
4) Make your selection with the number Key and input the # key.
5) the selected model is saved.
6) It is not displayed at the next boot after being set.
7) If you selected RM-6024 and nRM-8000A, you should set the ID for the device.
8) If you selected nRM-8000A, the nPX-8000 must be connected with the coM1 terminal. (the ID is set by
communicating with the Main System.)
9) Set the ID according to the 6000 System and nPX System.
※
ecS-6216P: 1 or 9, PX-6216: 1~8, nPX-8000: 1~4
When connecting RMe to ecS-6216P (in case of the RM of RMe connected to ecS-6216P Port1: 1~8, in
the case of the RM of RMe connected to eSc-6216P Port2: 9~16)