N-7301: Firefly Houseboat, N Scale: Kit Assembly Instructions: Rev 2013-1
Inter-Action Enterprises
Page 7
Now glue the outer and inner panels together taking care
to align them properly. Paint the vents and then paint and
glue on the bumper boards and the trim detail on each
side assembly.
9
Before gluing the wall assemblies to the floor
assembly, glue in the glazing (not shown, but glue the
window frames 8-3 to 8-9 to the inside of the walls,
centered on the window openings). The window
frames should be painted black.
Glue in both wall assemblies so that the slots and tabs
line up and the walls are flush with the bottom of the hull.
The inner wall should sit just above the interior floor.
NOTE: The photo does not show the glazing.
10
Glue in the aft cabin door glazing and frame 9-1 to the
aft cabin wall 9-2 and install in the slots in the boat
wall and floor.
Install the front lower wall section 10-1 into the slots in
the floor of the boat. Add any extra interior details that
you want.
11 I elected to install some lighting for the main cabin.
This is done by marking the location where you want
the lighting to go. In this case we are using 12V strip
LED’s.
Trim detail
8-1
Bumper board 8-2
Chrome Vents
Panel edges aligned
10-2
