EN
13
Make sure that you maintain the proper safety space as shown below around the equipment.
Safety Space and Insrallation
80cm/31inches
80cm/31inches
80cm/31inches
80cm/31inches
80cm/31inches
Installation
· Instructions stated in this manual must be performed during initial installation of the Intenza 550GC in order to ensure optimal
performance and a long lifespan. Please read and adhere to the following instructions carefully. If 550GC is not installed and
configured as described, the components may be subjected to excessive wear and tear and the bike may become damaged.
If you have any questions regarding installation, please contact us.
· Make sure the bike is level. If bike rocks on the floor, turn the levelling feet underneath the front and/or rear stabiliser until the
rocking motion is eliminated. Make sure that the levelling feet are not extended further than 10 mm.
· Verify emergency brake function to make sure that it is working properly.
· Check that both crank arm Allen bolts, with which the cranks (on the right and left side of the bottom bracket) are fastened, are
secure (tightening torque 60 NM). These bolts are provided with TufLok
®
at the factory to prevent them from becoming loose
during use. If the bolts become loose, we recommend applying medium—strength LOCTITE
®
243 and then re—attaching the
crank fixing bolts with a tightening torque of 60 NM.
· Wipe down bike frame with a rag moistened with solvent—free spray lubricant.
· Some parts of the bike may become loose during shipment. Check crank arms and all exposed screws, bolts and nuts, and make
sure that they are all secure and properly tightened.
Intenza 550GC Series Cycle Handbook: Installation
