Intellitouch Pool and Spa Control System, Installation Manual

Page: 37 / 46

31
IntelliTouch Personality Kit Installation Guide
Charging the MobileTouch Wireless Controller
When you are not using the MobileTouch controller, place it in the cradle to recharge the battery. This
allows the battery to be fully charged at all times.
To charge the MobileTouch controller battery:
• Plug the AC adapter into an AC wall outlet. Insert the AC Adapter plug into the bottom of the cradle
and place the MobileTouch controller in the cradle.
Note: When the MobileTouch controller is placed in the cradle the display and backlight will be on.
After five minutes the backlight will shut off. The MobileTouch controller and display are always on
when seated in the cradle. To turn the backlight on, press any button.
Charging the battery:
• If the battery screen icon displays one or no bars or the screen is blank, this may indicate that the
battery cannot power the device and needs recharging. During battery recharge, the battery icon
bars scroll from right to left. A complete battery charge takes about 3 to 4 hours. After a complete
battery recharge, the battery icon is replaced with a
power plug icon, indicating the battery is fully
charged and is now operating on AC power from the cradle. Note: If the battery requires
replacement, only use Pentair replacement battery (P/N 520815Z).
Using the MobileTouch Wireless Controller
The range of the MobileTouch wireless controller can be up to 300 feet from its transceiver antenna
(line of sight). The transceiver antenna is typically located outside near the IntelliTouch Load Center.
The device can be used all day at full power with a complete battery charge (3 to 4 hours).
To use the MobileTouch wireless controller:
1. Remove the MobileTouch wireless controller from the cradle. The controller can also be used while
seated in the cradle with AC power connected to the cradle.
2. Press the Power button on the front right-side to switch the unit ON. The main screen is displayed.
The LCD backlight will turn off in five minutes if not in use. The battery icon displays three bars,
indicating the battery is fully charged. Press the controller’s power switch to switch Off the device.
Sufficient charge left in the
batteries to operate device.
Cradle
Power On/Off button
MobileTouch Wireless Controller
MAIN SCREEN CHECK BATTERY ICONS
Ample battery charge. Bars
scroll right to left during
battery recharge.
Batteries will deplete soon.
Plug icon displays when
the battery is fully charged
and device is operating on
AC power from cradle.