background image

User Manual

Before using this unit, please read these operating instructions carefully.  

Afterwards, keep them handy for future reference.

Digital On-Hold Audio System

with analog line capability

1/2/3

3/4

POWER

ON

OFF

12V DC

AUDIO IN

TRIGGER

AUDIO O

UT VOL

UME

PHONE L

INES

Digital On-Hold Audio System

7

Other Functions

Remote Trigger

Location --  rear panel
Connection -- 2.5 mm mini jack
Operation -- By connecting a momentary switch to this jack, the unit will play 
audio content from memory when triggered.  Content will play through once 
and then reset, ready for next trigger sequence. 

AUX In

Location -- rear panel next to "TRIGGER" jack
Connection -- 3.5 mm mini jack
Operation -- Connect audio cable from the "LINE OUT" or "headphone out" jack 
of any external audio source to the "AUX IN" jack.

Additional Memory

The system comes standard with 8 minutes of flash memory which can be 
expanded to 16, 24 or 32 minutes. Memory modules can be placed into 3 
available memory expansion slots located on the circuit board.  Memory slots are 
accessed by removing the 5 screws on the bottom of the unit.

Settings

Impedance Switch

Location -- right side of unit
Operation -- Most telephone systems prefer an 8 ohm output.  If you are working 
with an older phone system, the 600 ohm setting  may be preferable.

  

Speaker Button

Location -- left top, located below the "REC" button
Operation -- Push "SPEAKER" button to listen to program playing from digital 
memory.  Push "SPEAKER" button again to turn off speaker.
Audio being recorded plays through speaker, regardless of speaker switch position.  
Speaker switch position has no effect on "AUDIO OUT" playback.

  

Volume Control

Location -- rear panel
Operation -- controls output level of "AUDIO OUT" jack. To adjust, turn control 
knob clockwise to increase volume.  Set proper volume level by calling in from a 
phone close to the unit (or cell phone) and having your call placed on hold.

Power Switch

Location -- rear panel
Operation -- turns power on or off.  When power is on, LCD is illuminated.

 

Digital On-Hold Audio System User Manual

OEM 4500 User's Manual 3/03

Summary of Contents for OHP 4500









Reviews: